1 door Access control kit with 300lb lock and software (1) ACC-910: Wiegand Proximity card reader (1) Acc-150: 300lb Electric magnetic lock This weather proof proximity card reader is a perfect access control device for outside doors in factories, office buildings, and other sensitive areas. Maximum distance is approx. 18cm (7 inches). If you need to control access at a security door, this indoor/outdoor proximity card reader is a perfect choice for large applications. Big and clear LCD display, 4 lines text, 1024 x 64 pixel graphic Different time zone for each user Auto-show work status (set via time zone edit) Master cards range assignable RS-485 support for networking (via controller or directly) Built-in door sensing and arming inputs (on/off) Auto open/close scheduling of doors Control mode, card capacity and card type assignable by user directly Built-in proximity reader and external Wiegand reader port Auto-discriminating between stand-alone & networking system Alarm function available (tamper, force entrance, door sense) Networking: RS-485, 9600, N, 8, 1 External reader port: Suitable for all WG, ABA reader, 125K, 13.56M (Mifare) or 2.4G reader RF Frequency / Reading range 125 kHz / 10-18cm Door relay: 12VDC @ 2A NO/NC/COM 0.1-600 sec. latch type Alarm relay: 12VDC @ 2A NO/NC/(jumper) 0.0-600 sec. (COM Common) DI input: Egress button / door sensor / card sensor Transistor output: Arming / door sensor / card sensor Tamper switch limit switch (form C) Serial port: supported for AI-401R016, LED display, relay board, printer ETC. (4800, N, 8, 1) Dimensions: 127mm x 91mm x 46mm (5" x 3.58" x 1.81") ACC-910: WIEGAND PROXIMITY CARD READER This Wiegand proximity access card reader is easy to install and is perfect for outside. Maximum distance is approx. 8cm (3.5 inches). Constructed of tough ABS plastic. Wiegand proximity card reader Sealed design for outdoor use Standalone or network operation when used with ACC900/ACC950/ACC995/ACC1000. o WG 26/34, ABAII, ASYNC 9600, N, 8, 1 Available ports: tamper switch, Wiegand port o 1024 w/card and PIN combination Anti-pass back: multi-door when used with ACC1000 Remote operation supported when used with ACC1000 Wiegand port: 1 (WG26, WG34) Reader range 8cm (3.5 inches) DI inputs: egress button, door contact, arming switch Power: 9-18VDC variable auto detection, 1W Temperature/humidity: -10 C - 50 C (14 F - 122 F) @ 0-90% relative humidity non-condensing Dimensions: 80mm x 43mm x 15mm (3.15" x 1.69" x .59") Acc-150: 300lb Electric magnetic lock ACC950 Reader Manual 2009.pdf (1331588 bytes) ACC-950 Reader Easy Guide.pdf (138060 bytes) (1 door access control kit with 300LB lock and software was posted and is owned by: Deana Odom) |
D_Odom@chicagopartsnetwork.com (Deana Odom)
for more information.