|
THIS IS A M100-XA4-OK VAR TRANSDUCER, SELF POWERED 120VAC L-L 3PHASE 3 WIRE , 5AAC CT RATED, 0-1 MADC OUTPUT M100-XA2 3 phase 3 wire balanced load M100-XA3 3 phase 4 wire balanced load M100-XA4 3 phase 3 wire unbalanced load M100-XA5 3 phase 4 wire unbalanced load M100-XA6 3 phase 3 wire unbalanced load M100-XA7 3 phase 3 wire balanced load internally The M100-XA series measure reactive power in single, 3 phase 3 or 4 wire balanced and unbalanced systems. Using the time division multiplier circuit means that they can be used over a wide range of input waveforms. The D.C. Output signal is directly proportional to the instantaneous reactive Typical applications include the measurement of reactive power in switchboards, power stations and generating sets etc. The high isolation of 4kV as with all the M100 series, allows these VAr transducers to be connected to a variety of measuring and control devices and systems, such as analogue meters, PLC, computers, data loggers, digital instruments Both auxiliary powered and self powered versions of each type are available, it is recommended to use an auxiliary powered version if the system being measured has voltage variations in excess of 20%. 1. Non standard inputs / outputs only as far as technically 2. A.C. Auxiliary in range 57.7 to 450 volts 3. Calibration at nominal Hz 35.....450Hz 4. Calibration at temperature other than 23 C Rated value In 1 or 5 Amp C.T. connected Rated value Un 57.8 < 600 volt Power consumption <1 VA voltage Working range 0-125% Un auxiliary powered Rated Frequency 50 / 60 / 400 Hz Overload continuous 4 x In 1.5 x Un Overload for 1 sec. 50 x In 2 x Un Rated value mA 0-1/5/10/20 & 4-20mA Rated Value Volts 0-5 / 10 & 1-5 V A.C. Voltage 115 / 230 / 400 V ( 25% / 45-65 D.C. Voltage 24 / 48 / 110 V ( 20% / M100-XA1,2,3,6,7 Approx. 0.6kg. 100mm case M100-XA4,5 Approx. 0.8kg 100mm case Product code I/P In Un O/P Range Aux. Freq. Opt. M100-XA4 400/5 400 0-20mA 300kVAr 120 60Hz http:// /PDFs/m100tran.pdf (Multitek M100-XA4OK var transducer 3P3W 1MADC output was posted and is owned by: Kristy Christian) |
Kristy-christian@chicagopartsnetwork.com (Kristy Christian) for more information.
