|
THIS A USED SONIC 15 STRIPPIT FABRICATOR WITH (3 1/2) 5 GALLON BUCKETS FULL OF PUNCHES AND DIES. DO NOT HAVE ENOUGH TIME IN THE WORLD TO LIST THEM ALL. THE CAPACITY IS 1/4" THICK BY 3/4" DIAMETER HOLE IN MILD STEEL. THIS MACHINE IS CAPABLE OF PUNCHING, NOTCHING, NIBBLING AND SAYS DRILLING BUT HAVE NOT FIGURED THAT ONE OUT. I SUSPECT THAT MEANS TO PUNCH A ROUND HOLE. IT HAS SOME SURFACE RUST FROM SITTING AROUND FOR AWHILE BUT SHOULD CLEAN UP FINE. IT WAS WORKING BUT I RAN OUT OF SPACE IN MY SHOP AND HAD TO MOVE IT OUTSIDE AND COVER IT UP WITH A TARP. SOME MAINTENANCE, CLEANING AND FLUID CHANGES SHOULD BE DONE BEFORE USING. *TABLE SIZE WITH SIDE WORK TABLE 56" WIDE X 24" DEEP * STOCK THICKNESS 1/4" MAXIMUM * SHUT HEIGHT (WITH PUNCHES AND DIES MOUNTED IN HOLDERS) 5-13/32" * THROAT DEPTHS FULL THROAT DEPTH 17" IT HAS THE 1 1/4" TOOL HOLDER BODY INCLUDED BUT THE 3 1/2" PUNCH HOLDER IS MISSING. THERE IS ALSO A STOP GAUGE INCLUDED BUT NO DUPLICATOR. THIS IS A ELECTRO-HYDROMATIC HEAD PRESS AND ONLY HAS A 1 HP MOTOR AND DRAWS 3.9 AMPS AND IS 220 3 PHASE. THERE IS SOME SMALL SHEET METAL DAMAGE ABOVE THE FLYWHEEL AS SEEN IN PICTURE BUT WILL NOT EFFECT THE FUNCTION OF THE MACHINE. I HAVE A WRECKER TO LOAD IT ON TO A TRAILER. (Sonic 15 strippit fabricator 1/4" x 3/4" capacity was posted and is owned by: Colleen Lowery) |
c_lowery@chicagopartsnetwork.com (Colleen Lowery) for more information.
