392A Vacuum Absorb & Down soldering Station NEW! having stronger absorb ability, little noise, continuum working time 1000 hours. Absorbing flat circuit-board, resistance & other small element. Vacuum pump in it, air system. Unnessary. Stronger absorb abiliy: attracting 130g. Removing static equipment : absorb-down pen, attracting pad, mading of eliminate material. Safty for senitive element. Power Supply 110V / 220V (KEEP IN STOCK) Vacuum Pump Pressure : 280mmHg Dimensions : Domination Station : Tube :1200(L) x 6 (Outer Diameter) Bend Absorbing Tip :Inside Diameter 0.4mm / 1.1 mm Absorb Pad :Outer Diameter :3mm/ 10mm/ 5mm 1. Insert the power into power receptacle. 2. Take on the vacuum absorb power (ON/OFF). When the switch adjusts to A. The absorb-pen is working,. When the switch adjust to B, the absorb-pen is working. When the switch adjust to AB, the absorb -pen AB is working.Absorb air button on the two side can control A.B absorb-pen air quantity. 3. When you absorb something, you must put your finger on shutoff air hole, and the pen procuces attracting strength in over to absorbing the element you want to get. If the air hole is turn on, the element will be down. 4. The single tip is use for attracting taping resistant, capacitance, and other small element. Attracting the big chip, you must set with the proper pad. 5. The element will be installed by your hand moving & put down in a prople position. (392A smd pick & place manual vaccum pump station was posted and is owned by: Sabrina Fulton) |
Sabrina-Fulton@chicagopartsnetwork.com (Sabrina Fulton)
for more information.