UNIVERSAL TRANSFER SWITCH CONTROLLER THAT CAN REPLACE ANY SINGLE VOLTAGE 0-300VAC Automatic Transfer Switch Control Module. The module features 8-Bit microprocessor control. The module is used to monitor two single-phase AC supply. Once mains AC supply failure is detected (under voltage, over voltage, under frequency, over frequency), The module will control generator to start. If generator AC can load, The module Automatically transfer the switch to generator AC supply, Micro-processor based design; Meter two single-phase AC Voltages; Set AUTO or MANUAL via PUSHBOTTON mounted on the front panel; Operational timers can be altered by PC; single-phase AC input: AC30 300V(+20%) 50/60Hz Relay of close mains & close gens: 16A 250VAC Relay of start generator: 10A 250VAC Mains Normal delay time: 0~3600s Mains Abnormal delay time: 0~3600s Gens Normal delay time: 0~3600s Start generator time:0~3600s(after Mains is abnormal) Stop generator time:0~3600s(after Mains is normal) Gens under frequency: 0~60.0Hz Gens over frequency:40.0~75.0Hz Operating Temperature Range: At MAN state push this button ATS will turn to the mains Switch the state to MAN or AUTO At MAN state push this button ATS will turn to the Generator Lighten when Module at auto state Lighten when Module at man state Lighten when mains is normal; Flicker when mains is abnormal; Die when mains is lost. Lighten when Generator is normal; Flicker when Generator is abnormal; Die when mains is lost. (Universal any transfer switch controler ats replacement was posted and is owned by: Ila King) |
iking@chicagopartsnetwork.com (Ila King)
for more information.