|
This is a OSTER pipe threading machine. It can do 2 1/2" to 4" pipe. There is a set of 3 1/2" - 4" NPT dies in it right now. 2 - sets of 2 1/2" - 3" NPT extras included. The threader has a 2 speed gear box. Hi/Low speeds. Has a 2 HP single phase drive motor, newer. Currently is wired for 230 volt, can also run 115 volt by changing wiring in the motor junction box. The on/off switch controls the motor starter below. Has overloads installed. The cord is about 20+ ft. long. The auto oiler motor starts pumping when the main motor is turned on. Internal oil ports drip the oil near the dies for lubrication of cutting area. Has a valve for shut off and control of oil flow. The quick release handle for the dies is cracked, however it has been repaired and functions properly. One of the pictures shows the detail. Vice jaws for holding pipe are in excellent condition. I tryed the threader on a piece of 4" sched 40. Threaded with ease, didn't slow down at all. The dies cut, but may need to be sharpened. I will be checking on line for additional dies for this. The threader is mounted to a steel base, with 4 wheel casters. Nice for job site portability. Threader was drained of oil and power washed. Blown dry, and all bare surfaces/ways were oiled right away. (Oster pipe threader plumbing threading machine tool big was posted and is owned by: Kenya Sanford) |
kenya.sanford@chicagopartsnetwork.com (Kenya Sanford) for more information.
