This hammer lock is used and in very good working order. If you work with sheet metal this tool will save you a ton time and money as it did me. I am no longer in the sheet metal business and therefore have no use for it any longer. The side handle on this unit is not original. I replaced it with a longer version. The MORLIN 5400 Hammer speeds up and takes the work out of the only tedious, costly, and time-consuming job of fabricating duct work- closing the "seam." This MORLIN tool breezes along at speeds of 15 feet per minute on commonly used gauges. Actually, it can save half of a man's time in making ducts, and do a better job. Just a couple of taps at the center and ends of a standard length duct to secure the lock . . . then the MORLIN Pittsburgh Lock Hammer does all the work. Handles 30 to 22 gauge (no adjustment required). For straight runs, inside or outside radius . . . use it in the shop or on the job. Weight rests on the work . . . position of handle affords positive control and balance . . . guides easily along the seam. HEAVY-DUTY BUILT 115V AC motor . . . more than enough power for any job. Sturdily built for heavy-duty use . . . ball and roller bearings throughout. (Morlin hammer lock was posted and is owned by: Joyce Rogers) |
Joyce-Rogers@chicagopartsnetwork.com (Joyce Rogers)
for more information.