|
BANNER MINI-BEAM SM312LVAG-68695 Photoelectric sensor Excellent - Items are tested,Functioning and Guaranteed not DOA. Great- Items looks presentable, Minor visible wear. This equipement is pulled from a working environement, it's been tested and Guaranteed not DOA. * 10 to 30V dc supply voltage with bipolar NPN/PNP outputs * Available in opposed, opposed clear plastic, polarized and non-polarized retroreflective, convergent, diffuse and divergent diffuse, and glass or plastic fiber optic sensing modes * Convergent and fiber optic models with infrared or visible red, blue or green LED light source, depending on application * Opposed-mode models for clear plastic detection * 18 mm threaded barrel or side mounting options 10 to 30V dc (10% max. ripple) @ less than 25 mA (exclusive of load) Opposed (clear plastic):0.3 m Non-polarized Retroreflective:5 m, range is specified using one model BRT-3 retroreflector Polarized Retroreflective:50 mm to 2 m, range is specified using one model BRT-3 retroreflector Polarized Retroreflective (extended range):10 mm to 3 m, range is specified using one model BRT-3 retroreflector Diffuse (short range):300 mm Convergent:16, 43 or 49 mm, depending on model Plastic and Glass Fiber Optic:Range varies by sensing mode and fiber optics used Protected against reverse polarity and transient voltages Bipolar:One NPN (current sinking) and one PNP (current sourcing); light operate (LO) or dark operate (DO) selectable 150 mA max. each output @ 25 C, derated to 100 mA @ 70 C (derate approximately 1 mA per C) OFF-state leakage current:less than 1 A PNP:less than 1V @ 10 mA and less than 2V @ 150 mANPN:less than 200 mV @ 10 mA and less than 1V @ 150 mA Protected against false pulse on power-up and continuous overload or short circuit of outputs Response time is independent of signal strength. Sensors will respond to either a light or dark signal of 1 millisecond or longer duration, 500 Hz max. Note:Models may be ordered with 0.3 millisecond ON/OFF by adding suffix MHS to the model number (example, SM312LVMHS). This modification reduces sensing range and excess gain. 100 milliseconds; outputs do not conduct during this time. Repeatability is independent of signal strength. Opposed:0.14 milliseconds Non-polarized and Polarized Retroreflective, Diffuse, Convergent, Glass and Plastic Fiber Optic:0.3 milliseconds Light/Dark-operate select switch and 15-turn slotted brass screw sensitivity (Gain) adjustment potentiometer, clutched at both ends of travel. Both controls are located on rear panel of sensor and protected by a gasketed, clear acrylic cover. Alignment Indicating Device system (AID) lights a rear-panel mounted red LED indicator whenever the sensor sees a light condition, with a superimposed pulse rate proportional to the light signal strength (the stronger the signal, the faster the pulse rate). Reinforced thermoplastic polyester housing, totally encapsulated, o-ring sealing, acrylic lenses and stainless-steel screws NEMA 1, 2, 3, 3S, 4, 4X, 6, 12 and 13; IEC IP67 PVC-jacketed 4-conductor 2 m or 9 m cables, or 4-pin Euro-style QD. QD cable are ordered separately. Relative humidity:90% @ 50 C (non-condensing) (Banner mini-beam SM312LVAG-68695 photoelectric sensor was posted and is owned by: Ramona Allison) |
R-allison@chicagopartsnetwork.com (Ramona Allison) for more information.
