Selling a brand new in bow Mico 12 volt fluid transfer pump. comes with 24" impeller. Complete set up ready to go. Here are a few links to get more information. http:// /specifications.htm http:// /pricing/MICO.pdf If you notice the cost of this unit you will see i'm almost giving it away! * Interchangeable with all MICO Standpipe Assemblies * Instantaneous fuel delivery * Ideal for use in multiple standpipe situations Delivery of Water in Gallons per Minute Total Discharge Head (Water)* 12 VDC OPERATION SPECIFICATIONS: * DUTY CYCLE of 30 minutes running time or approximately 420 gallons of water or gasoline. Prolonged dry running should be voided. 16 GPM maximum fluid capacity at outlet Complete unit pump weighs 25 lbs. Complete unit pumps consist of power head, standpipe, nozzle holder, hose, nozzle, and battery cable & clips. Power head alone weighs 10 lbs. A thermal overload protection circuit breaker is provided for the motor. We recommend the use of a 30 amp slow-blow fuse or circuit breaker (P/N 32-418-015) at the power source to provide cord protection. Power consumption at 12 VDC is 324 watts with a corresponding current draw of 27 amps. Electrical Connections are quick and easy. Simply connect one clip to the positive battery terminal and the other clip to the vehicle ground. The motor is a 1/4 H.P. permanent magnet, explosion proof type. It includes permanently lubricated precision ball bearings for armature support. The motor dose not require any lubrication. For use with all MICO Power Heads * Four lengths are available; 24", 30", 38" and 48". Custom lengths are possible. * Unique impeller design allows for almost 100% recovery of liquid from container. * Rotating collar adaptor allows installation without spinning entire pump and hose assembly 6012 power head with power head cord, 24" standpipe, nozzle holder, hose and nozzle. 6012 power head with power head cord, 30" standpipe, nozzle holder, hose and nozzle. 6012 power head with power head cord, 24" standpipe. 6012 power head with power head cord, 30" standpipe. FLUID COMPATIBILITY - Partial List The following is a partial list of fluids that may be used with MICO Standpipe Assemblies. A more complete application list is available upon request. Before using any solutions with MICO Standpipes other than those listed consult manufacturer. Gasoline, Diesel Fuel, Water, Anti-freeze, Butyl Alcohol, Dry Cleaning Fluids, Ethylene Glycol, Fuel oils (No. 1, 2 amd3), Glycols, Hydraulic Fluids, Insecticides (water base type), Jet Fuel (JP-4-5-6), Kerosene, Lacquer Solvents, Lubricating Oil, Methanol, Mineral Oil, Sea Water, Trichlorethlene, Toluene, Xylene. HERBICIDE COMPATIBILITY - Partial list The following is a partial list of commercially available herbicides that may be used with MICO Standpipe Assemblies. Before using any solutions with MICO Standpipes, other that those listed, consult manufacturer. Eptam, Eradicane, Sutazine, Sutan, Sutan + Mico Portable Liquid Transfer Pump (Mico portable liquid transfer drum pump was posted and is owned by: Nathaniel Barry) |
N.barry@chicagopartsnetwork.com (Nathaniel Barry)
for more information.