|
Large wheels, 10 inch diameter with a three inch wide hub where axle pin goes through. These are heavy duty with a one inch roller bearing. That requres the axle shaft to be one inch, as the roller bearings will run on this surface. A pc. of ground and polished stock or good quality cold rolled bar stock would work. If thomson shaft was used they would run better. these are heavy weights though i do not know what there rating is. They are made out of a fiber materal like micarda and are made to run on hard floor surfaces. would make a excellent hand cart or welder cart for a few ideas. there is a total of four wheels.
(Large wheels cart wagon table welder mechanic machinist was posted and is owned by: Antonio Figueroa) |
Antonio_Figueroa@chicagopartsnetwork.com (Antonio Figueroa) for more information.
