This is a set of 20 steel rule dies of various sizes. These are high quality dies that were used on a Markem label converting machine but they would work on most any die cutting application requiring a steel rule die. The machine was taken out of service so these dies are no longer needed. I can not specifically guarantee the quality of each die but there did work well the last time they were used. Any bad dies would have been replaced if it was defective when it was last used. The base block measures 4 ¾†X 4 ¼†X ¾†the rule is .918 rule or approximately 15/16†height The specific sizes are listed below in inches; 12.75 X 1.5 .09375 radius corners 3.92 X 1.71 .157 radius corners 3 X .875 .09375 radius corners 1.5 X .3125 .062 radius corners 2 across 1.5 X 1.5 .125 radius 2 across 1.125 X 1.625 .125 radius corners 1.75 X .625 X .25 square corners 2 part 1.4375 X .5625 one round corner 3.25 X 1 square corner with tab Please contact us with any questions. (Steel rule dies set of 20 was posted and is owned by: Ebony Ford) |
Ebony.Ford@chicagopartsnetwork.com (Ebony Ford)
for more information.